Technical Support

Selection guides, installation and maintenance notes for industrial solid tires.

Solid Tire Selection Guide

Match the tire to the machine and the surface. For counterbalanced forklifts on smooth concrete, press-on or pneumatic-rim solids give the best floor protection and lowest rolling resistance. For loaders and construction machinery on rough or abrasive ground, semi-solid or OTR solids with deep patterns last longer. For steel mills and slag handling, choose wide-section heat-resistant tires.

Check three numbers before ordering: the tire size (marked on the sidewall or in the machine manual), the rim diameter, and the axle load. Load ratings in our tables are per tire at the stated speed — add a safety margin of at least 10% for severe duty. When in doubt, send us the machine model and we will confirm the fitment.

Installation & Maintenance Notes

Select tires and rims that match each other — always pair the correct rim for the tire size.
On the same axle, fit identical size, brand and pattern — never mix.
Remove stones, nails and other foreign objects from the tread promptly to prevent carcass damage.
Match tire load capacity to the actual vehicle load — do not overload.
Check wheel nuts for tightness before putting a vehicle into service.
Do not park vehicles fully loaded for extended periods.

Where Solid Tires Work Best

Suitable vehicles: forklifts, loaders, scrapers, trailers, battery trucks and other low-speed industrial vehicles and equipment.

Suitable sites: stations, airports, docks and ports, warehouses, container yards, foundries, glass plants, steel mills, waste recycling plants and other surfaces that are reasonably flat and hard.

Not recommended for: sustained high-speed or long-distance highway transport — solid tires are engineered for low-speed, high-load industrial duty.

FAQ

What is the difference between press-on and pneumatic-rim solid tires?

Press-on tires are rubber molded onto a steel band and pressed onto a special wheel — best for indoor forklifts. Pneumatic-rim solids replace standard pneumatic tires on ordinary rims — easier to source wheels and simpler to fit with common tools.

Can solid tires be repaired like pneumatic tires?

They rarely need repair. There is no inner tube or air pressure; the tread simply wears down over time. When the tread reaches the wear line, the tire is replaced.

My size is not in your tables — can you make it?

Yes. We manufacture to order. Send the tire size, rim specification and the load you need to carry, and our engineers will confirm.

How do I choose between solid, semi-solid and pneumatic tires?

Rule of thumb: severe debris and heavy loads → solid; moderate duty with more comfort → semi-solid; light duty, high speed or lowest cost → pneumatic. Our team can advise for your specific site.

What certifications do your tires have?

ISO9001 quality system certification; products conform to GB (China), TRA (USA), ETRTO (Europe) and JATMA (Japan) standards.

Do you export? Which markets do you serve?

Yes — we export to Southeast Asia, Europe, India, the Middle East and other regions, with complete export documentation.